Belden, Colorado
Showing
21 - 28
of 28
, query time: 0.01s
Format:
Image
At right is the ball mill. At left is the rod mill. The mills are on an incline for gravity feed down to the loading docks.
At the center right of the photo, steel rods are stacked for use in the rod mill.
22) Surface tram
Format:
Image
The surface tram from Belden to the top of the mine complex at Gilman during a tour of the Gilman mine. The Grass Mountain Nightrider Snowmobile Club organized the tour. Durbin McIlnay would have been mine superintendent at that time.
There are 28 photos in this series taken by Bob Riggle, the only color series of which I'm aware. Should you question the captions or have further information, please let us know.
24) Transportation
Format:
Image
A sideview of the mantrip. Barry and Shirley Evans are at the back, Lucille Riggle in blue is facing the camera in front of them. Pete and Ella Burnett and Terry Pierson are in front.
25) Cap lamp room
Format:
Image
Berniece Chadwick, Alberta Limatta, and Ella Burnett with Hawkeye and Jean Flaherty behind them in the cap lamp room. The belts visible on Berniece and Ella hold a battery pack on the back with a power cord attaching to the lamp. Each lamp had 2 filaments so that if one burned out, the power could be switched to the second.
26) Mantrip
Format:
Image
Loading up for transportation to lower levels in the mine. The 16-10 incline goes down to the 18 level (at one time it went all the way to the 24 level). Transporting people was called a mantrip.
In the front seat are Terry Pierson, Ella and Pete Burnett. Victor Pierson is standing at left in the yellow helmet.
27) Cap Lamp Room
Format:
Image
From left, Bill Burnett, Hawkeye (Gordon) Flaherty, and Ella Burnett are standing in front of cap lamp units at 16 level in the Gilman mine. Alberta Limatta is at far right.
The shaft house had a 2 cage lift system, taking miners between levels. It could work with one cage going up and the other down, or with just one isolated cage moving. Cap lamps were put on before going into the mine and returned upon coming out.
Format:
Image
Drills and lathes in the repair area. Welders and machinists were employed by New Jersey Zinc to maintain and recycle equipment. During the 1950s, there were three shifts working each day to maintain production levels.
