Lathes Archive Search Results
Showing
1 - 7
of 7
, query time: 0.01s
Format:
Image
The lathes were for working steel. They could straighten bent drill steel, put new ends on the rods and send them back for reuse. The Gilman shop reused as much equipment and supplies as was possible.
Format:
Image
Frank Jones using one of the lathes to cut centers on the shaft of a bucket elevator tail pulley used in the Milling Department.
3. Repair shop
Format:
Image
More steel milling machiner in the repair shop. The lathe at center is approximately 20 feet long.
4. Lathes
Format:
Image
A closer look at the lathes.
Format:
Image
Frank Jones using a lathe for cutting centers on a shaft used by the Milling Department. "Jonesey" was known for his sense of humor and always seemed ready to share a joke.
Format:
Image
Frank Jones using one of the lathes to cut centers on the shaft of a bucket elevator tail pulley used in the Milling Department.
Format:
Image
Drills and lathes in the repair area. Welders and machinists were employed by New Jersey Zinc to maintain and recycle equipment. During the 1950s, there were three shifts working each day to maintain production levels.